Children's Health | Medical Gas and Vacuum System Troubleshooting 101

Resumen de Assessment

Se completó 0 de 8 Preguntas

Preguntas:

Ya has completado el assessment anteriormente. Por lo tanto, no puedes volver a iniciarlo.

Assessment se está cargando…

Debes iniciar sesión o registrarte para comenzar el assessment.

Primero debes completar lo siguiente:

Resultados

Assessment completado. Se están registrando los resultados.

Resultados

0 of 8 Preguntas answered correctly

Your time:

You have reached 0 of 0 point(s), (0)

Reseña
Respondido
Correcto
Incorrecto

Question 1 of 8

1. Question
Which of the following methods is recommended for detecting a leaky medical gas outlet?
- sound detection and feeling for a solid connection
- sniffing for a strong odor
- visually inspecting for discoloration of material from which the outlet is constructed
- utilizing a handheld leak detection device
Correct

Incorrect
Question 2 of 8

2. Question
What operational impacts would most likely result from failed medical vacuum pumps?
- complete loss of suction
- slow drains
- increased pressure at the oxygen outlets
- loss of water pressure
Correct

Incorrect
Question 3 of 8

3. Question
A “High CO” alarm displays on the main medical gas alarm panel. Which of the following descriptions best identifies with this alarm?
- The carbon monoxide sensor for the medical air pump is detecting a high level of carbon monoxide.
- The combined oxygen sensor for the medical air pump is detecting a high level of diatomic oxygen gas.
- The communication origin signal for the alarm panel is detecting a high operating temperature likely caused by a dirty intake filter on the vacuum pump.
- The carbon oxidation gradient sensor is detecting a high particulate count. The alarm panel filter is past due for preventative maintenance by the service provider.
Correct

Incorrect
Question 4 of 8

4. Question
Which of the following steps should be the initial course of action in response to a “Nitrous Oxide Reserve In Use” alarm?
- Remove the empty tanks from the bank that is off and hook up new tanks.
- Notify the surgical department (OR) to suspend cases until the alarm is resolved.
- Notify the Biomedical and Respiratory Care department to change out the medical gas tanks.
- Switch from nitrous oxide to oxygen until the alarm is resolved.
Correct

Incorrect
Question 5 of 8

5. Question
What happens if the dew point in a medical air system is too high?
- Could cause moisture to build up and cause bacteria growth
- Could cause the medical air compressor to shutdown
- Medical air pressure could become too low
- Medical air outlets could start leaking
Correct

Incorrect
Question 6 of 8

6. Question
Which test by a licensed vendor tests the presence of total hydrocarbons and halogenated hydrocarbons?
- Piping purity test
- Medical gas concentration test
- Cross-connection test
- System blowdown
Correct

Incorrect
Question 7 of 8

7. Question
A licensed vendor must be called to complete a blowdown on the system for what issue?
- Particles are found in the pure gases
- Any outlet or inlet is repaired
- Pure gases are found to be mixed
- Ice has built up on the oxygen tank
Correct

Incorrect
Question 8 of 8

8. Question
Which of the following steps should be the initial course of action in response to a local medical gas alarm in a patient room?
- Visually inspect the medical gas panel to determine if the regulator was left on or became loose.
- Shut off the medical gas tanks serving that area until the alarm is resolved.
- Relocate the patient to a different room until the medical gas supply is restored.
- Check power supply to the local medical gas panel. Reset the power supply to restore medical gas at the patient bed.
Correct

Incorrect

Children’s Health | Medical Gas and Vacuum System Troubleshooting 101

Children’s Health | Medical Gas and Vacuum System Troubleshooting 101

Resumen de Assessment

Información

Resultados

Resultados

Categorías

1. Question

2. Question

3. Question

4. Question

5. Question

6. Question

7. Question

8. Question