Children's Health | Plumbing System Operations 201

Resumen de Assessment

Se completó 0 de 8 Preguntas

Preguntas:

Ya has completado el assessment anteriormente. Por lo tanto, no puedes volver a iniciarlo.

Assessment se está cargando…

Debes iniciar sesión o registrarte para comenzar el assessment.

Primero debes completar lo siguiente:

Resultados

Assessment completado. Se están registrando los resultados.

Resultados

0 of 8 Preguntas answered correctly

Your time:

You have reached 0 of 0 point(s), (0)

Reseña
Respondido
Correcto
Incorrecto

Question 1 of 8

1. Question
Which of the following terms is best defined as the stationary portion of the valve that stops flow completely, when in contact with the movable portion?
- Valve seat
- Valve case
- Valve plug
- Valve port
Correct

Incorrect
Question 2 of 8

2. Question
Which of the following phrases best describes the function of expansion tanks in hydronic heating systems?
- Limits the increase in system pressure
- Limits the decrease in system pressure
- Limits the increase in system temperature
- Limits the decrease in system temperature
Correct

Incorrect
Question 3 of 8

3. Question
Which of the following phrases best describes how an expansion tank operates?
- Uses the pressure of air to control the pressure of an increased volume of water
- Uses compressed air to control the pressure of a decreased volume of water
- Prevents stored water from getting too cold or too hot
- Stores water in a single location so that it can be used in the system
Correct

Incorrect
Question 4 of 8

4. Question
What pipe material can be used for laboratory waste and vent applications?
- acid-resistant
- cast iron
- copper
- galvanized steel
Correct

Incorrect
Question 5 of 8

5. Question
What is the typical steam pressure for a domestic hot water heater?
- low pressure steam: 5 to 20 PSI
- high pressure steam: 60+ PSI
- medium pressure steam: 20 to 60 PSI
- extra-low pressure steam: less than 5 PSI
Correct

Incorrect
Question 6 of 8

6. Question
What is the protocol for turning the domestic hot or cold water over for domestic use after it has been down for 2 or more weeks?
- Flush water out from the system until the desired chlorine levels are achieved.
- Flush water out from the system until the water runs clear and tepid – minimum 3 minutes.
- Shock the domestic water system with additional chemical treatment for a minimum of 24 hours.
- Test the water for Legionella and treat accordingly.
Correct

Incorrect
Question 7 of 8

7. Question
Where should an isolation valve be installed in relation to the dielectric union when connecting two different piping materials?
- Immediately upstream of the union on the supply line
- Anywhere between the union and downstream of the equipment
- Immediately downstream of the union on the supply line
- Immediately upstream of the union on the return line
Correct

Incorrect
Question 8 of 8

8. Question
What type of backflow protection is typically used for a standard sink faucet?
- 2” minimum air gap between the space where the water comes from the faucet and the flood rim of the fixture
- backflow preventer
- check valve
- Backflow protection is not required on standard sink connections.
Correct

Incorrect

Children’s Health | Plumbing System Operations 201

Children’s Health | Plumbing System Operations 201

Resumen de Assessment

Información

Resultados

Resultados

Categorías

1. Question

2. Question

3. Question

4. Question

5. Question

6. Question

7. Question

8. Question